Engineering Transactions, 18, 3, pp. 353-370, 1970

Naprężenia Kontaktowe w Procesie Plastycznego Płynięcia Kształtowego Osiowo-Symetrycznego Stempla

L. Dietrich
Instytut Podstawowych Problemów Techniki, Warszawa

In the paper the method and results are given of the measurements of the normal contact stresses occurring on a frontal surface during compression in the plastic range of an axial-symmetrical stamp in the shape of a truncated cone. Experimental investigations were carried out for two batches of samples differing in the angle of inclination of the generator of the cone, made of lead. The distribution of normal stresses determined on the basis experiments differs essentially from the distribution calculated on the basis of the equation of the theory of plasticity. The graphs plotted on the basis of the performed measurements possess a distinct accumulation of the stresses on the external radius of the frontal surface; the degree of this accumulation is however smaller than it follows from solution of the theory of plasticity.
Full Text: PDF
Copyright © Polish Academy of Sciences & Institute of Fundamental Technological Research (IPPT PAN).


A. G. ATKINS, D. TABOR, Plastic indentation in metals with cones, J. Mech. Phys. Solids, 13 (1965), 149-164.

J. F. W. BISHOP, On the complete solution to problems of deformation of a plastic-rigid material, J. Mech. Phys. Solids, 2 (1953), 43-53.

L. DIETRICH, Nośność graniczna w zagadnieniach kontaktowych [w druku].

L. DIETRICH, W. SZCZEPIŃSKI, Plastic yielding of axially-symmetric bars with non-symmetric V-notch, Acta. Mech., 4 (1967), 230-240.

L. DIETRICH. K. TURSKI, Nośność graniczna rozciąganych osiowo-symetrycznych prętów osłabionych szeregiem karbów kątowych, Mech. Teor. i Stos., 6 (1968), 437-448.

G. EASON, R. T. SHIELD, The plastic indentation of a semi-infinite solid by a perfectly rough circular punch, ZAMP, 11 (1960), 33-42.

F. J. LOCKETT, Indentation of a rigid/plastic material by a conical indenter, J. Mech. Phys. Solids, 11 (1963), 345-355.

H. NEUBER, Kerbspannugslehre, Springer-Verlag, Berlin 1958.

R. E. PETERSON, Stress Concentration Design Factors, J. Willey, New York 1953.

R. T. SHIELD, On the plastic flow of metals under conditions axial symmetry, Proc. Roy. Soc., A, 233 (1955), 267-286.

W. SZCZEPIŃSKI, L. DIETRICH, E. DRESCHER, J. MIASTKOWSKI, Plastic flow of axially-symmetric notched bars pulled in tension, Int. J. Solids Structures, 2 (1966), 543-554.

N. P. SUH, R. S. LEE, C. R. ROGERS, The yielding of truncated solids cones under quasi-static and dynamic loading, 16 (1968), 543-554.

N. P. SUH, R. S. LEE, C. R. ROGERS, The yielding of truncated solid cones under quasi-static and dynamic loading, 16 (1968), 357-372.